Seven months of the year
AC in Seguin runs from April through October. That's most of the year with the compressor and fan cycling on, day after day, before the system gets much of a break.
Takes about a minute. No obligation.
AC in Seguin runs from April through October. That's most of the year with the compressor and fan cycling on, day after day, before the system gets much of a break.
June, July and August push the afternoon high to around 95°F here. Holding a set temperature against that kind of heat puts real strain on parts that are already worn or marginal.

NOAA nClimDiv, 1991–2020 normals
Texas homes paid 14.94 cents per kilowatthour in 2024.
An AC that's struggling to cool your Seguin home burns through that rate every time it cycles on.



March is worth a call before the heat sets in. AC in Guadalupe County switches on for the season in April and runs through October, and whatever a system is going to struggle with usually shows up in those first weeks of real load. A capacitor that got weak over the winter, a contactor with some wear on it, a low charge that wasn't quite low enough to notice last fall. All of it tends to surface once the compressor starts cycling on every day instead of sitting idle. Getting a system looked at in March, before that load hits, catches the weak part on your schedule instead of on the first hot afternoon of the season.
Your air conditioner works hard here, and that's usually what's behind the problem. Have it diagnosed properly so the fix lasts.
Find a contractor
If something's already acting up, that's seven months of daily cycling against a 95-degree afternoon catching up with a part that was already weak. A capacitor or contactor that's been marginal for a while won't hold up under that kind of load. Worth having someone check the actual part rather than just topping off refrigerant or resetting the thermostat, since a fix that skips the real cause tends to fail again before October.
Look at the outdoor unit and see if the fan is spinning. Check the thermostat is set to cool and set below room temperature, and swap the batteries if the screen is dim or blank. Go to the breaker panel and look for anything tripped, the outdoor unit and the indoor air handler each have their own. Pull the filter and hold it up to light. If you can't see through it, that alone can cause a lot of what feels like a bigger problem.
A tripped breaker or a dead thermostat battery looks exactly like a failed system from where you're standing. A clogged filter starves airflow across the indoor coil, which can ice it over or push the system into short cycling, so clearing it sometimes fixes the problem outright. If the fan's running, the breaker's fine and the filter's clean and it's still not cooling, that points to something inside the system itself, worth having a tech look at rather than guessing further.
Estimates for a typical Guadalupe County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Texas fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when a part like a capacitor or contactor has failed.
Replacement makes sense when the compressor has failed or the system uses R-22 refrigerant, which is no longer made.
A diagnostic starts outside at the condenser, checking that the compressor is running and the fan is turning the way it should, then moves to the refrigerant lines and the electrical connections feeding the unit. Gauges go on to check the charge, since too little or too much refrigerant both cause poor cooling in different ways. Inside, the tech checks the coil for ice or buildup and looks at airflow across it, because a coil that's starved for air will freeze up and stop cooling no matter what the compressor is doing. Capacitors and contactors get tested under load, not just looked at, since a weak capacitor can still look fine sitting still. The goal is to find which part is actually failing rather than replacing parts that seem like good guesses, so the fix holds instead of leaving the same weak part to fail again.
